Skip to main content

Q1 2022

Focus on: 100 Largest Losses in the Hydrocarbon Industry

In April, Marsh Specialty published the 27th edition of 100 Largest Losses in the Hydrocarbon Industry (100LL) report.
Dashboard-infographic-big-data-visualization

In April, Marsh Specialty published the 27th edition of 100 Largest Losses in the Hydrocarbon Industry (100LL) report. This publication summarizes the 100 largest property damage losses from the hydrocarbon extraction, transport, and processing industry between 1974 and 2021.

The report provides an opportunity to revisit lessons from the past, and identify key issues and trends from large losses, to understand improvements to operations and risk management practices.

There were only two new additions to the largest 100 ranking since our last report in 2020, with property damage costs of US$200 million and US$300 million respectively. This equates to the lowest average amount for any two-year period in the 100LL ranking since 1995/96 (see Figure 1). This is a remarkable change compared to the last few editions of the 100LL publication with 2018/19 contributing seven entries (totaling US$4.1 billion); 2016/17 contributing four entries (totaling over US$2.6 billion); and, 2014/15 contributing three entries (totaling US$1.4 billion).

Figure 1

The cost of the new additions to the 100LL shown on a two-year rolling basis.

The relatively low amount of US$250 million per year for 2020/21 is highlighted for ease of reference (orange line).

From a process safety perspective, the pandemic may have indirectly helped in the short-term. However, the medium to long-term impact remains to be seen.

Short-term reasons for a reduction in large loss events

The swift flurry of major losses that some feared at the start of the pandemic did not materialize. This is partly due to sites successfully managing the disruption to established work practices through well-executed business continuity plans. This included changes to staffing levels and management of associated fatigue risk for shift workers. There are also a number of factors that may have helped to mitigate potential process safety risks:

  • A “back to basics” approach by sites. New initiatives and changes were put on hold and steady operation was largely prioritized over optimization initiatives.
  • Planned turnarounds and major project commissioning works were postponed as sites struggled to source key materials and contractors — or where complex operations could not be completed in a “COVID-19 safe” manner. The reduction in both maintenance work and transient operations will have likely helped avoid a potential root cause for process safety incidents.
  • Many assets, particularly in upstream and refining, operated well below their maximum safe operating limits.

Medium to longer-term considerations and impacts

Moving forward, there are a number of potential risks that will need to be carefully managed to prevent potential “delayed losses”. Operators should consider the following:

  • Postponing turnarounds has meant that much planned inspection and maintenance work has been delayed. If the risks associated with deferring this critical work have not been properly managed, or if the backlog is not cleared in a timely fashion, this could be a common cause of losses in the coming years.
  • Assets being operated at minimum safe throughputs can have a negative impact on asset reliability, if not properly managed. Equipment may foul more easily, furnace tubes may coke more quickly, and rotating equipment, such as compressors and pumps, may be more prone to breakdown after periods of operating at minimum throughputs.
  • Many sites suspended emergency response drills during the pandemic due to challenges of working to COVID-19 safety guidelines. This may mean that emergency response teams are not as familiar with site-specific response plans, which could hamper any mitigation efforts, in the event of a fire or explosion.
  • A number of sites utilized remote work practices to complete scheduled hazard and operability studies (HAZOPs), project safety studies, or risk assessments as part of the management of change (MoC) process. If not properly managed, the quality of such safety analysis may be compromised.
  • Some organizations may have experienced a significant turnover of staff, including redundancies, since the start of the pandemic. The loss of experienced staff, particularly in any safety critical positions, will pose a clear risk if not adequately managed.
  • The financial impact of the pandemic on balance sheets may increase merger, acquisition, and divestment activity in the coming years. The disruption from a poorly managed ownership transition can precipitate process safety events in various ways.

Sector summaries

Gas processing

Seven property damage losses associated with gas processing feature among the 100 largest losses — the most recent was a fire that occurred in Norway in September 2020.

The properties of LNG mean that the risk of internal corrosion is greatly reduced and significant global experience with the design, construction, and operation of LNG facilities has helped contribute to the relatively limited incidents of very large losses in this sector. The September 2020 fire reportedly occurred because, “the anti-icing heat exchanger in the air inlet was used outside of its intended area of application.”[i] This serves as a reminder that the potential does exist for high-consequence losses in this sector due to their complexity and value.

Petrochemical

There have been no new additions to the 100LL from this sector over the last two years. However, there have been some notable petrochemical losses, including two in South Korea: Daesan in March 2020 and Yeosu in November 2020.

Although it doesn’t qualify for the 100LL, a major explosion at a petrochemical plant in Tarragona, Spain, in January 2020 resulted in three fatalities. One of these fatalities occurred several kilometers from the site, caused by a one-metric ton projectile. This demonstrates the potentially significant third-party liability exposures for this sector. 

A number of factors contribute to petrochemical plant loss history. They often contain a concentration of high-value equipment and machinery, typically operate at high temperatures and pressures, and require the careful control of potentially violent chemical reactions. However, materials processed at petrochemical plants have normally been pre-processed (for example, supplied by oil refineries), meaning that most contaminants in the feedstocks will have been removed prior to receipt, making them less susceptible to several corrosion mechanisms.

Refining

One new refinery loss was added to this edition of the 100LL, and refinery losses now make up 37% of the largest losses. The incident occurred in Cape Town, South Africa, in July 2020.

In general, oil refineries are a group of aging assets. Older assets have often been subject to both expansion projects to increase capacity, and retrospective installation of high-value, high-conversion assets. Together these have resulted in higher concentration of value at sites. Refineries process crude oil and therefore, have a far more dynamic and broad feedstock range than the other asset classes.

The combination of aging assets, increased concentration of value, and diverse feedstocks, are all likely to have contributed to the fact that this sector makes up the largest proportion of the 100LL.

Terminals and distribution

Only seven losses associated with terminal and distribution operations feature among the 100LL; the most recent occurring in 2005. The physical layout of most terminal and distribution assets, coupled with the value of the plant and its equipment, means that few sites have enough concentration of value to result in the very largest physical damage losses. 

Upstream

The upstream sector accounts for 23% of the 100LL. However, it’s important to remember that the report only covers property damage, and does not include the additional costs of good control, or third-party liability. The total third-party liability claims for the Macondo loss in the Gulf of Mexico in 2010, are understood to be more than 40 times the value of the associated property damage loss.

The most recent upstream loss to be included in the 100LL occurred in February 2016 and the five subsequent years mark the longest period without an upstream addition to the 100LL ranking since the period 1993 to 2001.

[i] Investigation of the fires at Tjeldbergodden and Hammerfest now concluded

Fast facts

With a total of 37 losses, the refining sector has the highest proportion of losses, followed by petrochemicals with 26 losses, and 23 losses in the upstream sector.

It has been over five years since a major loss in the upstream sector, the most recent incident added to the top 100 was in February 2016.

Six of the 20 highest value losses, and 19 of the 100 losses, occurred in the last 10 years.

32% of losses resulted from an explosion; 24% from mechanical failures; and 13% from a natural catastrophe event.

North America and Europe recorded the most losses, with 37 and 25 losses respectively. Latin America, and the Middle East & Africa regions both have 14 losses; and Asia Pacific has recorded 10.

The adjusted property loss values range from US$2.3 billion to US$189 million.

Q1 2022

Energy & Power Insurance Quarterly Newsletter

 

Previous editions